Glaze Coat Epoxy Not Drying

If fish eyes do occur add more epoxy to the spot with the issue before it cures.

Glaze coat epoxy not drying.

If your epoxy has already cured and you have fish eyes you will need to pour another coat over the epoxy. An alternative option would be to use epoxy resin cement. After pouring you will want to wait a full 24 hours then check that the surface is dry and not tacky. Often caused by inaccurate measuring not mixing thoroughly or by curing in cold temperatures.

Finally you will apply a very thin coat of epoxy to seal and restore the shine to the countertop. With higher temperatures cure time decreases. Sticky or soft spots are the result of. Try moving your piece to.

After epoxy is poured and has cured for 36 hours the surface should be hard and smooth. Unfortunately deviating from the 1 1 mixing ratio does the exact opposite. Hold dryer at least 6 inches from the surface. Famowood glaze coat is a pour on epoxy coating that can be used on most surfaces rough or smooth stained or painted.

To speed drying time apply heat using a handheld dryer set on low. Sticky or soft spots. Causes can include not following the correct 1 1 ratio of resin and hardener or by adding too much colorant. The liquid resin will need to be scraped off before you pour a fresh coat.

It s great for coating tables or bar tops preserving photographs or imbedding decorative items. With lower temperatures and higher humidity cure time increases. Just one coat equals 70 coats of. A full cure takes 24 to 72 hours depending on the surrounding environment.

How long does amazing goop take to dry.